MasterChef RSH013931 User's Guide download pdf (Page 21)

Argos/RSH-013931/012012 20

20

Troubleshooting

Problem

Possible Cause

Prevention/Cure

Burner will not

light using igniter

Wires or electrode covered with cooking

residue.

Clean wire and/or electrode with rubbing

alcohol.

Electrode and burners are wet.

Wipe dry with cloth.

Electrode cracked or broken - sparks at

crack.

Replace electrode.

Wire loose or disconnected.

Reconnect wire or replace electrode/wire

assembly

Wire is shorting (sparking) between igniter

and electrode.

Replace igniter wire/electrode assembly.

Burner will not

light with long

match or taper

No gas flow.

Check if LP gas bottle is empty. If empty,

replace or refill. If LP gas bottle is not empty,

refer to “Sudden drop in gas flow or reduced

flame height”.

Coupling nut and regulator not fully

connected.

Turn the coupling nut an additional one-half

to three quarters until firm. Tighten by hand

only - do not use tools.

Obstruction of gas flow.

Clear burner pipe. Check for bent or kinked

hose.

Disengagement of burner to valve.

Re-engage burner and valve.

Spider webs or insect nest in venturi.

Clean venturi.

Burner ports clogged or blocked.

Clean burner ports.

Sudden drop in gas

flow or reduced

flame height

Out of gas.

Replace or refill LP gas bottle.

Excess flow safety device may have been

activated.

Turn control knobs to “OFF”. Wait 30

seconds and re-light. If flames are still too

low, reset the excessive flow safety device

(built-in within the internal structure of the

regulator) by turning control knobs “OFF”

and LP gas bottle valve to “CLOSED” using

the regulator lever. Disconnect regulator.

Turn control knobs to “HIGH”. Wait 1 minute.

Turn control knobs to “OFF”. Reconnect

regulator and check connections for leaks.

Slowly turn the regulator lever to “OPEN”

(flame showing on lever). Wait 30 seconds

and then light grill per lighting instructions.

Irregular flame

pattern, flame does

not run the full

length of burner.

Burner ports are clogged or blocked.

Clean burner ports.

Flame is yellow or

orange.

New burner may have residual

manufacturing oils.

Burn grill for 15 minutes with the lid closed

Spider webs or insect nest in venturi

Clean venturi.

Food residue, grease or seasoning salt on

burner.

Clean burner.

Poor alignment of valve to burner venturi.

Ensure side burner/venturi is properly

engaged with valve.

1 2 ... 16 17 18 19 20 21 22

Comments to this Manuals

No comments